| PAX expansion cards |
|
|
|
|
|
| Red Lion Controls - USA | | PAXCDL10 PAX Analog Output Plug-in Card | | | | 0/4-20mA or 0-10V analogue output card for PAX meters | | Resolution 1/3500 | | For Use with PAX Units Only |
|
|
PAXCDL10 Analogue output card
|
|
 |
|
|
|
| Red Lion Controls - USA | Digital output cards for PAX/LPAX/EPAX meters PAXCDS10 Dual relay PAXCDS20 Quad relay PAXCDS30 Quad NPN transistor PAXCDS40 Quad PNP transistor | | Various output modules | | Relay versions - dual changeover or quad Form-A | | Transistor versions - NPN and PNP (100mA) |
|
|
PAXCDS Digital output cards
|
|
 |
|
|
|
| Red Lion Controls - USA | Comms cards for PAX series panel meters PAXCDC10 - RS485 PAXCDC20 - RS232 PAXCDC30 - DeviceNet PAXCDC40 - Modbus PAXCDC4C - Modus w/RJ11 PAXCDC50 - Profibus PAXCDC1C - RS485 w/RJ11 PAXCDC2C - RS232 w/9 pin D | | RS232 Half Duplex | | RS485 Multi-Point Balanced Interface | DeviceNet: Supports Polling, Bit Strobe and Explicit Message commands. Baud Rates of 125K, 250K, or 500K | MODBUS: RS485 RTU and ASCII MODBUS modes. Baud Rates to 38400 | Profibus: Cyclic I/O Data Transmission, up to 84 bytes in/out. Baud Rates of 9.6K to 12MB with Auto Baud Rate Detection |
|
|
PAXCDC Communications cards
|
|
 |
|
|
|
| Red Lion Controls - USA | | PAXUSB00: USB programming module | For Use with PAX Units Only (PAXCK, PAXD, PAXDP, PAXH, PAXI, PAXP, PAXS, PAXT) Not for use with PAX Lite models USB Virtual Comms Port USB Cable Available (CBLUSB01) | CUB5 meters can be programmed using Crimson 2 (Download free from the 'Crimson 2 Download' section |
|
|
PAXUSB00 USB Programming module
|
|
 |
|
|
|
| Red Lion Controls - USA | | CBLUSB01 USB cable | | USB cable for PAX series panel meters (CBLUSB01) | | Type A-Mini B, 5 feet long |
|
|
Red Lion CBLUSB01 USB cable
|
|
 |
|
|
|
| Red Lion Controls - USA | Engineering unit label kits PAXLBK10 Label kit for PAX meters and PAXLA PAXLBK30 Label Kit for PAX Lite meters | | Used with 5 digit PAX units | | 189 different engineering units, 1 frame | | Fits inside the display | | Backlight is enabled via programming | | Note: Please use the PAXLBK10 for the PAXLA meter |
|
|
PAXLBK Label kit for PAX analogue meters
|
|
 |